#Att uverse no signal on tv update#
#Att uverse no signal on tv tv#

Amber: There’s a software update in progress. The power status lights on your Wi-Fi® gateway indicate: Green: The gateway is powered on. What is happening with ATT Uverse? What lights should be on my AT router? Try using an Ethernet cable to connect to your DIRECTV STREAM device instead of Wi-Fi. Check your internet or Wi-Fi® connection and test your signal strength using your remote: Press the Home button, then Settings > Help > Troubleshooting > Run Network Diagnostics.

#Att uverse no signal on tv tv#

Why is the red light flashing on my ATT TV box? But the most important difference: the first-year monthly price. Using your U-verse TV remote control: Press Menu. While some may think the two companies are the same, DIRECTV and AT U-verse offer similar services. Try Troubleshoot & Resolve on your TV from the comfort of your recliner. U-verse unfortunately no longer exists, but we recommend you check out AT’s streaming cable-like service, DIRECTV STREAM. If your TV uses a cable or satellite box, you may need to contact your service provider for further assistance in improving the signal strength. Change the channel or try a different input device or movie. Wait up to 10 minutes for the gateway or modem to restart and your Broadband light to turn solid green.Ĭheck the cable connections between the TV and your video device or receiver.Put the internal battery back in if you have one.Unplug the power cord from the back of your gateway or modem.Pull the power cord out of the back of the box.Hold the power button down for 10 secs.Restart your Wi-Fi® Gateway by removing the power cord for one minute then plugging it back in. This process takes 5-8 minutes and will impact any DVR recordings in progress.

Restart your TV receiver by holding the POWER button down for 10 seconds then pressing it again to restart. If you have multiple receivers, reboot your wireless gateway by unplugging it from its power source.

This takes 5-8 minutes and will impact any DVR recordings in progress. To do this, press and hold the Power button for 10 seconds. Many receiver problems can be fixed by restarting your receiver. Why is my TV suddenly saying no signal?.If pairing is successful, the Link light on your wireless receiver should turn green. Move your wireless receiver closer to the WAP, then pair them by pressing the WPS button on your WAP and the OK button on your wireless receiver. Your receiver may be too far away from your WAP. If you don’t see a red light or the red light is dim, replace the batteries in the remote.Ĭonnection error on TV or receiver and Wireless Access Point (WAP) not pairing If you see a red light, the batteries are still good. Receiver doesn't respond to the remote controlĬheck the batteries in the remote by pressing the AT&T button on the remote. To stop your receiver from going to standby, simply press a key such as OK, Guide, or Options on your U-verse remote to restart the eight-hour cycle. This feature is in place to conserve energy. Be sure the proper input/source setting is selected.Īfter eight hours of inactivity, your receiver automatically goes to standby mode.

Receiver power is on and TV power is on, but I still can't see TVĬheck your TV menu setup. If you’re having a specific problem and restarting the receiver doesn’t fix it, try the tips below. Wait a few minutes, then plug it back in.